FAQs
GENERAL QUESTIONS
We are the world leader in decorative mouldings. All polystyrene and polyurethane products are manufactured in Belgium.
Both the Polyurethane and the styrene are very strong and durable. They will not chip or break if dropped. Cuts or bad dents can be filled with the adhesive and lightly sanded (120g sandpaper).
Yes. Noel & Marquet products are both Solvent free and CFC free. They can safely be used in infant or children’s room.
Indefinitely under normal conditions. Even in humid conditions the NMC mouldings cannot be damaged by water (i.e. bathrooms).
No, very little. Approximately 5% of the total product required, rounded up to the nearest 2m length.
Direct heat, too close to the mouldings, can damage the surface. (Polystyrene products are more sensitive to heat than the Polyurethane products). The larger cornices can however be used for concealed lighting, using either low voltage or fluorescent lights, with approximately 6cm clearance.
The polystyrene is cheaper of equivalent to any of its competitors. The polyurethane range is more expensive due to the sophisticated technology that goes into the product, but due to the substantial savings on the indirect costs, such as installation, wastage or breakage, the product works out comparatively cost effective.
ADHESIVE/ GLUE
We recommend Noel & Marquet ‘2-in-1’ adhesive (Adefix P5) product, specifically designed for use with the Noel & Marquet mouldings, which is both an adhesive and filler.
Using the Noel & Marquet adhesive, the moulding will bond instantly. Panel pins should be used to support joints whilst adhesive dries. If the moulding is not positioned correctly you have approximately 10 minutes to correct or remove it before adhesion sets.
The adhesive can be used on most surfaces including tiles, steel, glass, wood and
plastered surfaces. The latter should be primed prior to installation.
The Noel & Marquet adhesive should completely dry/set within 24 hours. (Drying time is subject to weather conditions or humidity).
- Per 5kg tub
- Small profile 60 meter
- Medium profile 40 meter
- Large profile 30 meter.
The above are guidelines only, and depend on the finish of walls i.e. rough plaster or bricks would require more adhesive as would skew walls and ceilings. The tubs of adhesive are more economical as any excess adhesive can be recycled. The cartridge with cone nozzle is perfect for easy fillings and finishing, especially in corners.
The Noel & Marquet Adhesive / Filler has a 6mm bridging capacity. The adhesive can be sanded to achieve a smooth finish.
Note: When joining profiles, always leave a 2-3mm gap, filled with adhesive. This acts as an expansion joint and prevents cracking on joints.
Noel & Marquet Adhesive is water based and therefore easy to clean. Simply wipe clean immediately and it won’t leave a stain.
PAINTING
This is not advised, as the mouldings would yellow over time.
Yes, with any paint.
Almost any special paint effect can be applied to the mouldings.
The product is suitable for D.I.Y. applications. For professional installation, contact Power Surface Decor for recommended installers.